White Papers

Parameters
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses
the switch dynamically learns. Optionally, you can also add one of these
combinations: address/mac-address, interface/interface, or vlan
vlan-id.
static (OPTIONAL) Enter the keyword static to display only those MAC addresses
specifically configured on the switch. Optionally, you can also add one of these
combinations: address/mac-address, interface/interface, or vlan
vlan-id.
address mac-
address
(OPTIONAL) Enter the keyword address then a MAC address in the
nn:nn:nn:nn:nn:nn format to display information on that MAC address.
interface
interface
(OPTIONAL) Enter the keyword interface then the interface type, slot and port
information:
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
interface
interface-type
(OPTIONAL) Instead of entering the keyword interface then the interface type,
slot and port information, as above, you can enter the interface type, then just a
slot number.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to display the MAC
address assigned to the VLAN. The range is 1 to 4094.
count (OPTIONAL) Enter the keyword count, then optionally, by an interface or VLAN
ID, to display total or interface-specific static addresses, dynamic addresses, and
MAC addresses in use.
Command Modes
● EXEC
● EXEC Privilege
Supported Modes
Programmable-Mux (PMUX)
Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage
Information
The following describes the show mac-address-table command shown in the following example.
Column
Heading
Description
VlanId Displays the VLAN ID number.
Mac Address Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Type Lists whether the MAC address was manually configured (Static), learned
dynamically (Dynamic), or associated with a specific port (Sticky).
Interface Displays the interface type and slot/port information. The following abbreviations
describe the interface types:
● gi — Gigabit Ethernet then a slot/port.
● po — Port Channel then a number. The range is from 1 to 255 for TeraScale.
● so —SONET then a slot/port.
● te — 10 Gigabit Ethernet then a slot/port.
State Lists if the MAC address is in use (Active) or not in use (Inactive).
Layer 2 739