White Papers

mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a topology
change.
Syntax
[no] mac-address-table station-move refresh-arp
Defaults Enabled
Command Modes CONFIGURATION
Supported Modes
Programmable-Mux (PMUX)
Full–Switch
Command
History
Version Description
9.9(0.0) Modified the default option from none to Enabled. Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
For details about using this command, refer to the “NIC Teaming” section of the Layer 2 chapter in the
Dell Networking OS Configuration Guide.
mac learning-limit
Limit the maximum number of MAC addresses (static + dynamic) learned on a selected interface.
Syntax
mac learning-limit address_limit [dyanmic] [no-station-move| station-move]
[sticky]
Parameters
address_limit Enter the maximum number of MAC addresses that can be learned on the
interface. The range is from 1 to 1000000.
dynamic (OPTIONAL) Enter the keyword dynamic to allow aging of MACs even though a
learning limit is configured.
no-station-move (OPTIONAL) Enter the keywords no-station-move to disallow a station move
(associate the learned MAC address with the most recently accessed port) on
learned MAC addresses.
station-move (OPTIONAL) Enter the keywords station-move to allow a station move on
learned MAC addresses.
sticky (OPTIONAL) Enter the keyword sticky to allow configuring the sticky mac
feature along with the learning limit.
Defaults dynamic
NOTE: “Static” means manually entered addresses, which do not age.
Command Modes INTERFACE
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command and its options are supported on physical interfaces, static LAGs, LACP LAGs, and VLANs.
Layer 2 735