White Papers

Adjacency being used for MTs: IPv4 IPv6
Dell#
show isis protocol
Display IS-IS routing information.
Syntax
show isis protocol
Command Modes
● EXEC
● EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
The bold section identifies that Multi-Topology IS-IS is enabled.
Dell#show isis protocol
IS-IS Router: <Null Tag>
System Id: F100.E120.0013 IS-Type: level-1-2
Manual area address(es):
49.0000.0001
Routing for area address(es):
49.0000.0001
Interfaces supported by IS-IS:
GigabitEthernet 1/0 - IP - IPv6
GigabitEthernet 1/1 - IP - IPv6
GigabitEthernet 1/10 - IP - IPv6
Loopback 0 - IP - IPv6
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics: level-1-2
Generate wide metrics: none
Accept wide metrics: none
Multi Topology Routing is enabled in transition mode.
Dell#
show isis traffic
This command allows you to display IS-IS traffic interface information.
Syntax
show isis traffic [interface]
Parameters
interface (OPTIONAL) Identifies the interface type slot/port as one of the following:
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Command Modes
● EXEC
● EXEC Privilege
Supported Modes Full–Switch
Intermediate System to Intermediate System (IS-IS) 717