White Papers

peer-group-name Enter the name of the peer group. All routers in the peer group receive routes from
a route reflector.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The first time you enter this command it configures the neighbor as a route reflector and members of the
route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully meshed if you configure a
route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route reflector.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ipv6-address [route-map map-name]
To remove a network, use the no network ipv6-address [route-map map-name] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of an established
route map.
If the route map is not configured, the default is deny (to drop all routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The software resolves the network address configured by the network command with the routes in
the main routing table to ensure that the networks are reachable using non-BGP routes and non-default
routes.
Related
Commands
redistribute — redistributes routes into BGP.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static} command.
664 IPv6 Border Gateway Protocol (IPv6 BGP)