White Papers

Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
neighbor default-originate
Inject the default route to a BGP peer or neighbor.
Syntax
neighbor {ipv6-address | peer-group-name} default-originate [route-map map-
name]
To remove a default route, use the no neighbor {ipv6-address | peer-group-name}
default-originate command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group to set the default route of all routers in that peer
group.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of a configured route
map.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
neighbor distribute-list
Distribute BGP information using an established prefix list.
Syntax
neighbor {ipv6-address | peer-group-name} distribute-list prefix-list-name
{in | out}
To delete a neighbor distribution list, use the no neighbor {ipv6-address | peer-group-
name} distribute-list prefix-list-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group.
prefix-list-name Enter the name of an established prefix list. If the prefix list is not configured, the
default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
660 IPv6 Border Gateway Protocol (IPv6 BGP)