White Papers

Usage
Information
If the number parameter is the same as the AS number used in the router bgp command, the remote
AS entry in the neighbor is considered an internal BGP peer entry.
This command creates a peer and the newly created peer is disabled (shutdown).
Related
Commands
router bgp — enters the ROUTER BGP mode and configure routes in an AS.
neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
Syntax
neighbor {ipv6-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ipv6-address | peer-group-name} remove-
private-as command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group to remove the private AS numbers.
Defaults Disabled (that is, the private AS number are not removed).
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Applies to external border gateway protocol (EBGP) neighbors only.
If the AS-PATH contains both public and private AS number or contains AS numbers of an EBGP
neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software removes the private AS
numbers only if they follow the confederation numbers in the AS path.
Private AS numbers are from 64512 to 65535.
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Syntax
neighbor {ipv6-address | peer-group-name} route-map map-name {in | out}
To remove the route map, use the no neighbor {ipv6-address | peer-group-name}
route-map map-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group.
map-name Enter the name of an established route map. If the Route map is not configured,
the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
IPv6 Border Gateway Protocol (IPv6 BGP) 633