White Papers

capture bgp-pdu neighbor (ipv6)
Enable capture of an IPv6 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv6-address direction {both | rx | tx}
To disable capture of the IPv6 BGP neighbor packet, use the no capture bgp-pdu neighbor
ipv6-address command.
Parameters
ipv6-address Enter the IPv6 address of the target BGP neighbor.
direction {both |
rx | tx}
Enter the keyword direction and a direction — either rx for inbound, tx for
outbound, or both.
Defaults Not configured.
Command Modes
● EXEC
● EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
capture bgp-pdu max-buffer-size — enables route reflection between the route reflector and the clients.
show capture bgp-pdu neighbor — configures a route reflector and clients.
capture bgp-pdu max-buffer-size
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
100-102400000 Enter a size for the capture buffer.
Defaults 40960000 bytes
Command Modes
● EXEC
● EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
capture bgp-pdu neighbor (ipv6) — enables route reflection between the route reflector and the clients.
show capture bgp-pdu neighbor — configures a route reflector and clients.
clear ip bgp * (asterisk)
Reset all BGP sessions in the specified category. The soft parameter (BGP Soft Reconfiguration) clears the policies without
resetting the TCP connection.
Syntax
clear ip bgp * [ipv4 multicast soft [in | out] | ipv6 unicast soft [in |
out] | soft [in | out]]
614 IPv6 Border Gateway Protocol (IPv6 BGP)