White Papers

Defaults none
Command Modes
● EXEC
● EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ipv6 route command shown in the following examples.
Field Description
(undefined) Identifies the type of route:
● L = Local
● C = connected
● S = static
● R = RIP
● B = BGP
● IN = internal BGP
● EX = external BGP
● LO = Locally Originated
● O = OSPF
●
IA = OSPF inter-area
● N1 = OSPF NSSA external type 1
● N2 = OSPF NSSA external type 2
● E1 = OSPF external type 1
● E2 = OSPF external type 2
● i = IS-IS
● L1 = IS-IS level-1
● L2 = IS-IS level-2
● IA = IS-IS inter-area
● * = candidate default
● > = non-active route
● + = summary routes
Destination
Identifies the route’s destination IPv6 address.
Gateway Identifies whether the route is directly connected and on which interface the route
is configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
Example
Dell#show ipv6 route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally
Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
Gateway of last resort is not set
Destination Dist/Metric, Gateway, Last Change
-----------------------------------------------------
C 100::/64 [0/0]
Direct, Te 0/8, 20:00:18
C 400::/64 [0/0]
Direct, Tu 1, 00:09:02
IPv6 Basics 601