White Papers

clear ipv6 route
Clear (refresh) all or a specific route from the IPv6 routing table.
Syntax
clear ipv6 route {* | ipv6-address prefix-length}
Parameters
* Enter the * to clear (refresh) all routes from the IPv6 routing table.
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix length in the /x
format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
clear ipv6 mld_host
Clear the IPv6 MLD host counters and reset the elapsed time.
Syntax
clear ipv6 mld_host
Command Modes EXEC
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ipv6 address autoconfig
Configure IPv6 address auto-configuration for the management interface.
Syntax
ipv6 address autoconfig
To disable the address autoconfig operation on the management interface, use the no ipv6 address
autoconfig command.
Default Disabled
Command Modes INTERFACE (management interface only)
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Infomation
● SAA can configure up to two addresses. If any preferred prefix or valid timers time out, the
corresponding address are deprecated or removed. If an address is removed due to a time-out, an
IPv6 Basics 587