White Papers

<0-4> Number of FP blocks for IPV6 (multiples of 2)
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
ipv6 access-list
Configure an access list based on IPv6 addresses or protocols.
Syntax
ipv6 access-list access-list-name cpu-qos {permit | deny} ospfv3
To delete an access list, use the no ipv6 access-list access-list-name command.
Parameters
access-list-name Enter the access list name as a string, up to 140 characters.
cpu-qos Enter the keyword cpu-qos to assign this ACL to control plane traffic only
(CoPP).
permit Enter the keyword permit to configure a filter to forward packets meeting this
condition.
deny Enter the keyword deny to configure a filter to drop packets meeting this
condition.
ospfv3 Specify that this ACL is for OSPFv3 control plane traffic
Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packet is dropped.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added support for CoPP for OSPFv3 on the MXL 10/40GbE Switch IO Module.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The number of entries allowed per ACL is hardware-dependent. For detailed specification on entries
allowed per ACL, refer to your line card documentation. You can create an IPv6 ACL for control-plane
traffic policing for OSPFv3, in addition to the CoPP support for VRRP, BGP, and ICMP that existed in Dell
Networking OS releases 9.3(0.0) and earlier
Related
Commands
show config — views the current configuration.
ipv6 control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
IPv6 Access Control Lists (IPv6 ACLs) 581