White Papers

Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-mem or
copy run start), then reload the system.
The total amount of space allowed is 16 FP blocks. System flow requires three blocks and these blocks
cannot be reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10.
The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
cam-acl-egress
Allocate space for IPv6 egress ACLs.
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default Use the default CAM profile settings, and set the CAM as follows:
● L2 ACL(l2acl): 1
● L3 ACL (ipv4acl: 1
● IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4 ipv4acl
1- 4 ipv6acl 0-4
Allocate space to support IPv6 ACLs. Enter all of the profiles and a range. Enter the
CAM profile name then the amount to be allotted. The total space allocated must
equal 13. The ipv6acl range must be a factor of 2.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-mem or
copy run start), then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and these blocks
cannot be reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10.
The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
Example
Dell#
Dell#configure
Dell(conf)#cam-acl-egress ?
default Reset Egress CAM ACL entries to default setting
l2acl Set L2-ACL entries
Dell(conf)#cam-acl-egress l2acl ?
<1-4> Number of FP blocks for l2acl
Dell(conf)#cam-acl-egress l2acl 1 ?
ipv4acl Set IPV4-ACL entries
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ?
ipv6acl Set IPV6-ACL entries
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
580 IPv6 Access Control Lists (IPv6 ACLs)