White Papers

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show ip route list test
Codes:C- connected, S - static, R - RIP,
B- BGP, IN - internal BGP, EX - external BGP,LO - Locally
Originated,
O- OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2- OSPF NSSA external type 2, E1 - OSPF external type 1,
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate default,
>- non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 2.1.0.0/24 via 2.1.4.1, Te 4/4 120/2 3d0h
R 2.1.1.0/24 via 2.1.4.1, Te 4/4 120/2 3d1h
R 2.1.2.0/24 via 2.1.4.1, Te 4/4 120/1 3d0h
R 2.1.3.0/24 via 2.1.4.1, Te 4/4 120/1 3d1h
C 2.1.4.0/24 Direct, Te 4/4 0/0 3d1h
Related
Commands
ip prefix-list — enters CONFIGURATION-IP PREFIX-LIST mode and configures a prefix list.
show ip prefix-list summary — displays a summary of the configured prefix lists.
show ip route summary
View a table summarizing the IP routes in the switch.
Syntax
show ip route summary
Command Modes
● EXEC
● EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip route summary shown in the following example.
Column
Heading
Description
Route Source Identifies how the route is configured in the system.
Active Routes Identifies the best route if a route is learned from two protocol sources.
Non-active
Routes
Identifies the back-up routes when a route is learned by two different protocols. If
the best route or active route goes down, the non-active route becomes the best
route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised, then
information on those routes is displayed.
Total 1388
active...
Displays the number of active and non-active routes and the memory usage of
those routes. If there are no routes configured in the the system, this line does not
appear.
568 IPv4 Routing