White Papers

Command Modes
● EXEC
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
The following describes the show ip fib stack-unit command shown in the following example.
Field Description
Destination Displays the destination route of the index.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 otherwise.
C Displays the CPU bit.
1 indicates that a packet hitting this entry is forwarded to the control processor,
depending on Egress port.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the entry to determine the
interface. For example, in the entry 17cl CP, the CP is the pertinent portion.
● CP = control processor
● Fo= 40 Gigabit Ethernet interface
● Te = 10 Gigabit Ethernet interface
Example
Dell#show ip multicast-cam stack-unit 0 port-set 0 10.10.10.10/32
longer-prefixes
Destination EC CG V C VId Mac-Addr Port
----------------- -- -- - - ----- ----------------- -------------
10.10.10.10 0 0 1 1 0 00:00:00:00:00:00 3f01 CP
Dell#
show ip protocols
View information on all routing protocols enabled and active on the switch.
Syntax
show ip protocols
Command Modes
● EXEC
● EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show ip protocols
Routing Protocol is "bgp 1"
Cluster Id is set to 20.20.20.3
Router Id is set to 20.20.20.3
IPv4 Routing 565