White Papers

show ip udp-helper
Display the configured UDP helpers on all interfaces.
Syntax
show ip udp-helper
Defaults none
Command Modes EXEC
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show ip udp-helper
--------------------------------------------------
Port UDP port list
--------------------------------------------------
Te 1/1 656, 658
Te 1/2 All
Related
Commands
debug ip udp-helper — enables debug and displays the debug information on a console.
ip udp-broadcast-address — configures a UDP IP address for broadcast.
ip udp-helper udp-port — enables the UDP broadcast feature on an interface either for all UDP ports or a
specified list of UDP ports.
Port Interface Commands
The following commands are for physical, loopback, and null interfaces:
● clear counters
● clear mac-address-table dynamic
● interface range
● interface vlan
● keepalive
● name
● show config (INTERFACE mode)
● show config (from INTERFACE RANGE mode)
● show config (from INTERFACE VLAN mode)
● show interfaces configured
● show interfaces description
● show interfaces stack-unit
● show interfaces port-channel
● show interfaces status
● show interfaces switchport
● show vlan
● shutdown
● speed (for 1000/10000 interfaces)
Virtual LAN (VLAN) Commands
The following commands configure and monitor virtual local area networks (VLANs). VLANs are a virtual interface and use many
of the same commands as physical interfaces.
You can configure an IP address only on the default VLAN. FTP, TFTP, ACLs, and SNMP are not supported on a VLAN.
Interfaces
527