White Papers

Line Description
Rate
information...
Estimate of the input and output traffic rate over a designated interval (30 to 299
seconds). Traffic rate is displayed in bits, packets per second, and percent of line
rate.
Time since... Elapsed time since the last interface status change (hh:mm:ss format).
Usage
Information
The interface counter “over 1023-byte pkts” does not increment for packets in the range 9216 > x <1023.
The Management port is enabled by default (no shutdown). If necessary, use the ip address
command to assign an IP address to the Management port.
Example
(ManagementEth
ernet)
Dell#show interface managementethernet ?
0/0 Management Ethernet interface number
Dell#show interface managementethernet 0/0
ManagementEthernet 0/0 is up, line protocol is up
Hardware is DellForce10Eth, address is 00:1e:c9:f1:00:05
Current address is 00:1e:c9:f1:00:05
Pluggable media not present
Interface index is 235159752
Internet address is 10.11.209.87/16
Mode of IP Address Assignment : MANUAL
DHCP Client-ID: mgmt001ec9f10005
Virtual-IP is not set
Virtual-IP IPv6 address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 100 Mbit, Mode full duplex
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 5d4h57m
Queueing strategy: fifo
Input 3448753 packets, 950008323 bytes, 3442163 multicast
Received 0 errors, 0 discarded
Output 4627 packets, 814226 bytes, 0 multicast
Output 0 errors, 0 invalid protocol
Related
Commands
show interfaces configured — Displays any interface with a non-default configuration.
show interfaces port-channel — Displays information on all interfaces on a specific stack unit.
show interfaces switchport — Displays Layer 2 information about the interfaces.
show inventory — Displays the I/O Aggregator type, components (including media), Dell Networking OS
version including hardware identification numbers and configured protocols.
show ip interface — Displays Layer 3 information about the interfaces.
show memory — Displays the stack unit(s) status.
show interfaces status — Displays all interfaces configured using the interface range command.
show interfaces configured
Displays any interface with a non-default configuration.
Syntax
show interfaces configured
Command Modes
● EXEC
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
504 Interfaces