White Papers

Example
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/7
no ip address
switchport
no shutdown
Dell(conf-if)#
show config (from INTERFACE RANGE mode)
Display the bulk configured interfaces (group).
Syntax
show config
Command Modes CONFIGURATION INTERFACE (conf-if-range)
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
show interfaces
Displays information on a specific physical interface or virtual interface.
Syntax
show interfaces interface
Parameters
interface Enter one of the following keywords and slot/port or number information:
● For the management interface on the stack-unit, enter the keyword
managementethernet followed by slot/port information. The slot and port
range is 0.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN interface, enter the keyword vlan followed by a number from 1 to
4094.
● For a Port Channel interface, enter the keyword port-channel followed by a
number. The range is from 1 to 128.
Command Modes
● EXEC
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Usage
Information
Use this show interfaces command for details on a specific interface. Use the show interfaces
stack-unit command for details on all interfaces on the designated stack unit.
On the I/O Aggregator, the show interface output displays incorrect rate information details over time
for link monitoring when the rate-interval is configured for 5 seconds. Dell Networking recommends using
higher rate-intervals such as 15 to 299 seconds to minimize the errors seen.
502 Interfaces