White Papers

Version Description
9.11.0.0 Introduced on all Dell Networking OS platforms.
Usage
Information
The output of the show interfaces command displays the configured rate interval, along with the
collected traffic data.
When rate-interval is not configured in the global configuration mode or interface mode, the default value
of 299 seconds is applied.
When rate-interval is configured only in the global configuration mode and not in the interface mode, the
global rate-interval value is applied at the interface level also.
When rate-interval is configured at the interface level and not in the global configuration mode, the
interface level rate-interval value is applied for an interface.
When rate interval is configured in both global configuration mode as well as interface mode, then the
rate-interval value configured at interface level is applied as it takes precedence over the global value.
remote-fault-signaling rx
Brings the interface up or down when a Remote Fault Indication (RFI) error is detected.
Syntax
remote-fault-signaling rx {on | off}
Parameters
on Brings the interface up when an RFI error is detected.
off Brings the interface down when an RFI error is detected.
Defaults ON.
Command Modes INTERFACE CONFIGURATION
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL switch.
Usage
Information
By default, the switch processes the RFI errors transmitted by remote peers and brings down the
interface when an RFI error is detected.
Example
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
show config
Display the interface configuration.
Syntax
show config
Command Modes INTERFACE
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Interfaces 501