White Papers

MTU 12000 bytes, IP MTU 11982 bytes
LineSpeed 10000 Mbit
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 03:56:48
Queueing strategy: fifo
Input Statistics:
User Information
Both sides of the link must have auto-negotiation enabled or disabled for the link to come up.
The following details the possible speed and auto-negotiation combinations for a line between two
10/100/1000 Base-T Ethernet interfaces.
Port 0
● auto-negotiation enabled* speed 1000 or auto
● auto-negotiation enabled speed 100
● auto-negotiation disabled speed 100
● auto-negotiation disabled speed 100
● auto-negotiation enabled* speed 1000 or auto
Port 1
● auto-negotiation enabled* speed 1000 or auto
● auto-negotiation enabled speed 100
● auto-negotiation disabled speed 100
● auto-negotiation enabled speed 100
● auto-negotiation disabled speed 100
Link Status Between Port 1 and Port 2
● Up at 1000 Mb/s
● Up at 100 Mb/s
● Up at 100 Mb/s
● Down
● Down
* You cannot disable auto-negotiation when the speed is set to 1000 or auto.
Related
Commands
speed (for 1000/10000 interfaces) — sets the link speed to 10, 100, 1000 or auto-negotiate the speed.
portmode hybrid
To accept both tagged and untagged frames, set a physical port or port-channel. A port configured this way is identified as a
hybrid port in report displays.
Syntax
portmode hybrid
To return a port to accept either tagged or untagged frames (non-hybrid), use the no portmode
hybrid command.
Defaults non-hybrid
Command Modes INTERFACE (conf-if-interface-slot/port)
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
498 Interfaces