White Papers

Examples
Dell(conf)#int vlan 1
Dell(conf-if-vl-1)#
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related
commands
show vlan — Displays the current VLAN configuration on the switch.
vlan tagged — Adds a Layer 2 interface to a VLAN as a tagged interface.
vlan untagged — Adds a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled.
Syntax
intf-type cr4 autoneg
If you configure intf-type cr4 autoneg, use the no intf-type cr4 autoneg command to set
the interface type as cr4 with autonegotiation disabled.
Defaults Not configured
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
If you configure interface type as CR4 with auto-negotiation enabled, also configure CR4 with
auto-negotiation. Many DAC cable link issues are resolved by setting the interface type as CR4.
Related
Commands
interface — configures a physical interface.
interface port-channel — configures a port channel group.
keepalive
Send keepalive packets periodically to keep an interface alive when it is not transmitting data.
Syntax
keepalive [seconds]
To stop sending keepalive packets, use the no keepalive command.
Parameters
seconds (OPTIONAL) For interfaces with PPP encapsulation enabled, enter the number of
seconds between keepalive packets. The range is from 0 to 23767. The default is
10 seconds.
Defaults Enabled.
Command Modes INTERFACE
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
492 Interfaces