White Papers

interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
Syntax
interface range macro name
Parameters
name Enter the name of an existing macro.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example (Single
Range)
This example shows the macro named test that was defined earlier.
Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,te-5/0-8)#
Related
Commands
interface range — configures a range of command (bulk configuration).
interface range macro (define) — defines a macro for an interface range (bulk configuration).
interface vlan
Configure a VLAN. Configure the default VLAN to enable Static or DCHP IP configuration. You can configure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
vlan-id Enter 1 for the default VLAN. Enter a number as the VLAN identifier. The range is
from 1 to 4096.
Defaults Not configured, except for the default VLAN, which is configured as VLAN 1.
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
For more information about VLANs and the commands to configure them, refer to Virtual LAN (VLAN)
Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC/IP ACLs are not supported.
Interfaces 491