White Papers

Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)# no shutdown
Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)#
Related
commands
show config (from INTERFACE RANGE mode) — Shows the bulk configuration interfaces.
show interfaces status — Displays a summary of interface information.
interface range macro (define)
Defines a macro for an interface range and then saves the macro in the running configuration.
Syntax
define interface range macro name interface , interface , ...
Parameters
name Enter up to 16 characters for the macro name.
interface,
interface,...
Enter the keywords interface range and one of the interfaces — slot/
port, port-channel, or VLAN number. Select the range of interfaces for bulk
configuration. You can enter up to six comma-separated ranges. Spaces are not
required between the commas. Comma-separated ranges can include VLANs, port-
channels, and physical interfaces.
Slot/Port information must contain a space before and after the dash. For example,
interface range tengigabitethernet 0/1 - 5 is valid; interface
range tengigabitethernet 0/1-5 is NOT valid.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example (Single
Range)
This example shows how to define an interface range macro named test. Execute the show running-
config command to display the macro definition.
Dell(config)# define interface-range test tengigabitethernet0/0-3,
tengigabitethernet 5/0-7
Dell# show running-config | grep define
define interface-range test tengigabitethernet0/0-3,
tengigabitethernet5/0-7,
Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,te-5/0-7)#
Related
Commands
interface range – configures a range of command (bulk configuration)
interface range macro name – runs an interface range macro.
490 Interfaces