White Papers

off off off off
off off off off
off on on off
off off off off
off off off off
on off off on
on on on on
on on on on
off off off off
off off off off
on on on on
on on on on
Related
Commands
show running-config — displays the flow configuration parameters (non-default values only).
interface
Configure a physical interface on the switch.
Syntax
interface interface
Parameters
interface Enter one of the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an interface
in mode, ensure that the interface’s configuration does not contain an IP address and enter the Port
Channel Commands command. By default, the interface is shut down when the portmode hybrid
and switchport are enabled.
The tunnel interface operates as an ECMP (equal cost multipath) only when the next hop to the tunnel
destination is over a physical interface. If you select any other interface as the next hop to the tunnel
destination, the tunnel interface does not operate as an ECMP.
Example
Dell(conf)#interface tengig 0/1
Dell(conf-if-te-0/1)#exit#
Related
Commands
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
486 Interfaces