White Papers

Version Description
9.14(0.0) Introduced on the platforms S4048–ON, S6100–ON, Z9100–ON, S4048T-ON,
S3048–ON, S6000, S6010–ON, S5048F-ON, FN-IOM, and MXL.
9.13(0.2P2) Introduced on the S3100.
Usage
Information
Whenever the Err-disable recovery timer is reconfigured, it will get effective only after the current timer
expires. Following message is displayed after each Err-disable recovery timer configuration:
DellEMC(conf)# errdisable recovery interval 30
New timer interval will be effective from the next timer instance only.
Related
Commands
errdisable recovery cause — Enable automatic recovery of an interface from the error disabled state.
flowcontrol
Controls how the system responds to and generates 802.3x pause frames on 10G and 40Gig stack units.
Syntax
flowcontrol rx {off | on} tx {off | on} pause-threshold value [monitor
session-ID]
Parameters
rx on Enter the keywords rx on to process the received flow control frames on this
port. This is the default value for the receive side.
rx off Enter the keywords rx off to ignore the received flow control frames on this
port.
tx on Enter the keywords tx on to send control frames from this port to the connected
device when a higher rate of traffic is received. This is the default value on the
send side.
tx off Enter the keywords tx off so that flow control frames are not sent from this
port to the connected device when a higher rate of traffic is received.
pause-threshold Enter the buffer threshold limit for generating PAUSE frames.
monitor Enter the keyword monitor then the session-ID to enable mirror flow control frames
on the interface. The range is from 0 to 65535.
Defaults
● rx off
● tx off
Command Modes INTERFACE
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command
History
Version Description
9.11(0.0) Added support for monitor session.
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The globally assigned 48-bit Multicast address 01-80-C2-00-00-01 is used to send and receive pause
frames. To allow full-duplex flow control, stations implementing the pause operation instruct the MAC to
enable the reception of frames with a destination address equal to this multicast address.
The pause:
484 Interfaces