White Papers

Interfaces
This chapter defines the interface commands on the Aggregator switch.
Topics:
• Basic Interface Commands
• Port Channel Commands
• Time Domain Reflectometer (TDR) Commands
• UDP Broadcast
• Port Interface Commands
• Virtual LAN (VLAN) Commands
Basic Interface Commands
The following commands are for Physical, Loopback, and Null interfaces.
clear counters
Clear the counters used in the show interfaces commands for VLANs, and physical interfaces, or selected ones.
Syntax
clear counters interface
Defaults Without a specific interface specified, the command clears all interface counters.
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/port or number to clear
counters from a specified interface:
● For the management interface on the stack-unit, enter the keyword
managementethernet followed by slot/port information. The slot and port
range is 0.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
● For a Port Channel interface, enter the keyword port-channel followed by a
number. Range: 1-128
NOTE: This command also enables you to clear the port configurations
corresponding to a range of ports.
● You can specify multiple ports as slot/port-range. For example, if you
want to clear the port configurations corresponding to all ports between 1
and 4, specify the port range as show interfaces interface-type
1/1 - 4.
Command Modes EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to clear the interface configurations
corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
24
Interfaces 479