White Papers

protocol frrp
Enter the Resilient Ring Protocol and designate a ring identification.
Syntax
protocol frrp {ring-id}
To exit the ring protocol, use the no protocol frrp {ring-id} command.
Parameters
ring-id Enter the ring identification number. The range is from 1 to 255.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command places you into the resilient ring protocol. After executing this command, the command line
prompt changes to conf-frrp.
show frrp
Display the resilient ring protocol configuration.
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
ring-id Enter the ring identification number. The range is from 1 to 255
summary (OPTIONAL) Enter the keyword summary to view just a summarized version of the
Ring configuration.
Defaults none
Command Modes EXEC
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Executing this command without the optional ring-id command clears the statistics counters on all
the available rings. The system requires a command line confirmation before the command executes. This
command clears the following counters:
● hello Rx and Tx counters
● Topology change Rx and Tx counters
● The number of state change counters
Example
(Summary)
Dell#show frrp summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
----------------------------------------------
2 UP Master 2 11-20, 25,27-30
31 UP Transit 31 40-41
50 Down Transit 50 32
Dell#
Force10 Resilient Ring Protocol (FRRP) 459