White Papers

Command Modes CONFIGURATION (conf-frrp)
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command causes the Ring Manager to take ownership of the two ports after IFM validates the
configuration. Ownership is relinquished for a port only when the interface does not play a part in any
control VLAN, that is, the interface does not belong to any ring.
Related
Commands
show frrp — displays the resilient ring protocol configuration information.
member-vlan
Specify the member VLAN identification numbers.
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
vlan-range Enter the member VLANs using VLAN IDs (separated by commas), a range of
VLAN IDs (separated by a hyphen), a single VLAN ID, or a combination. For
example: VLAN IDs (comma-separated): 3, 4, 6. Range (hyphen-separated): 5-10.
Combination: 3, 4, 5-10, 8.
Defaults none
Command Modes CONFIGURATION (conf-frrp)
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
mode
Set the Master or Transit mode of the ring.
Syntax
mode {master | transit}
To reset the mode, use the no mode {master | transit} command.
Parameters
master Enter the keyword master to set the Ring node to Master mode.
transit Enter the keywordtransit to set the Ring node to Transit mode.
Defaults Mode None
Command Modes CONFIGURATION (conf-frrp)
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
458 Force10 Resilient Ring Protocol (FRRP)