White Papers

Example
Dell#show fips status
FIPS Mode : Disabled
Dell#
Dell#show fips status
FIPS Mode : Enabled
Dell#
show ip ssh
Display information about established SSH sessions
Syntax
show ip ssh
Defaults none
Command Modes EXEC
EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show ip ssh
SSH server : enabled.
SSH server version : v1 and v2.
Password Authentication : enabled.
Hostbased Authentication: disabled.
RSA Authentication : disabled.
Vty Encryption HMAC Remote IP
1 3des-cbc hmac-md5 10.1.20.48
2 3des-cbc hmac-md5 10.1.20.48
With FIPS Mode enabled:
Dell#show ip ssh
SSH server : enabled.
SSH server version : v2.
Password Authentication : enabled.
Hostbased Authentication : disabled.
RSA Authentication : disabled.
Vty Encryption HMAC Remote IP
0 aes128-cbc hmac-sha1 10.11.8.13
1 aes128-cbc hmac-sha1 10.1.20.48
ssh
Open an SSH connection specifying the hostname, username, port number, and version of the SSH client.
Syntax
ssh {hostname | ipv4 address | ipv6 address} [-c encryption cipher | -l
username | -m HMAC alogorithm | -p port-number | -v {1|2}]
Parameters
hostname (OPTIONAL) Enter the IP address or the hostname of the remote device.
ipv4 address (OPTIONAL) Enter the IP address in dotted decimal format A.B.C.D.
ipv6 address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prefix length
in the /x format. The range is from /0 to /128
FIPS Cryptography 439