White Papers

arp inspection-limit
Configure dynamic ARP inspection rate-limit to verify the rate of ARP packet received in a port on a specific interval.
Syntax
arp inspection-limit {rate pps [interval seconds]}
Defaults None
Command Modes INTERFACE CONFIGURATION
Supported Modes Full-Switch
Parameters
rate pps Enter the keyword rate then the packet per second (pps) value. The range is
from 1 to 2048. The default is 15.
interval seconds (Optional) Enter the keyword intervalthen the burst interval in seconds. The
range is from 1 to 15. The default is 1.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the S3048-ON, S4048-ON, S4048T-ON, S3100 Series, Z9100-ON,
S6100-ON, S6000, S6000-ON, S6010-ON, S5048F-ON, S4810, S4820T, FN IOM
and MXL.
arp inspection-trust
Specify a port as trusted so that ARP frames are not validated against the binding table.
Syntax
arp inspection-trust
Defaults Disabled
Command Modes
● INTERFACE
● INTERFACE PORT-CHANNEL
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
arp inspection — enables dynamic ARP inspection on a VLAN.
clear ip dhcp snooping
Clear the DHCP binding table.
Syntax
clear ip dhcp snooping binding
Defaults none
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Dynamic Host Configuration Protocol 409