White Papers

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
show ip dhcp conflict
Display the address conflict log.
Syntax
show ip dhcp conflict address
Parameters
address Display a particular conflict log entry.
Defaults none
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
show ip dhcp server
Display the DHCP server statistics.
Syntax
show ip dhcp server statistics
Defaults none
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Commands to Configure the System to be a DHCP
Client
To configure the system to be a DHCP client, use the following commands.
ip address dhcp
Acquire an IP address dynamically on an interface from the DHCP server.
Syntax
ip address dhcp [relay | vendor-class-identifier]
To disable DHCP Client on an interface, use the no ip address dhcp command.
Command Modes INTERFACE
Supported Modes All Modes
Default Enabled
404 Dynamic Host Configuration Protocol