White Papers

Version Description
9.4(0.0) Supported on the FN I/O aggregator. This command is supported in
Programmable-Mux (PMUX) mode only.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
(Summary)
Dell#show interfaces te 0/3 pfc statistics
Interface TenGigabitEthernet 0/3
Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
--------------------------------------------------------
0 0 0 0
1 0 0 0
2 0 0 0
3 0 0 0
4 0 0 0
5 0 0 0
6 0 0 0
7 0 0 0
show qos priority-groups
Displays the ETS priority groups configured on the switch, including the 802.1p priority classes and ID of each group.
Syntax
show qos priority-groups
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this command as it has been
deprecated in the current 9.4(0.0) release. A warning message appears when you try to run this
command indicating that you have to use the dcb-map commands in the future.
Example
Dell#show qos priority-groups
priority-group ipc
priority-list 4
set-pgid 2
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters configured in the specified map.
Command Modes
● EXEC
● EXEC Privilege
Data Center Bridging (DCB) 389