White Papers

show interface ets
Displays the ETS configuration applied to egress traffic on an interface, including priority groups with priorities and bandwidth
allocation.
Syntax
show interface port-type slot/port ets {summary | detail}
Parameters
port-type slot/
port ets
Enter the port-type slot and port ETS information.
{summary |
detail}
Enter the keyword summary for a summary list of results or enter the keyword
detail for a full list of results.
NOTE: This command also enables you to view information corresponding to a range of ports.
● You can specify multiple ports as slot/port-range. For example, if you want to display
information corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1 - 4.
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the interface
configurations corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To clear ETS TLV counters, use the clear ets counters interface port-type slot/port
command.
The following describes the show interface summary command shown in the following example.
Field Description
Interface Interface type with stack-unit and port number.
Max Supported
TC Group
Maximum number of priority groups supported.
Number of
Traffic Classes
Number of 802.1p priorities currently configured.
Admin mode ETS mode: on or off. When on, the scheduling and bandwidth allocation configured
in an ETS output policy or received in a DCBX TLV from a peer can take effect on
an interface.
Admin
Parameters
ETS configuration on local port, including priority groups, assigned dot1p priorities,
and bandwidth allocation.
Remote
Parameters
ETS configuration on remote peer port, including admin mode (enabled if a valid
TLV was received or disabled), priority groups, assigned dot1p priorities, and
bandwidth allocation. If ETS admin mode is enabled on the remote port for DCBX
exchange, the Willing bit received in ETS TLVs from the remote peer is included.
Local Parameters ETS configuration on local port, including admin mode (enabled when a valid TLV
is received from a peer), priority groups, assigned dot1p priorities, and bandwidth
allocation.
Operational
status (local
port)
Port state for current operational ETS configuration:
● Init: Local ETS configuration parameters were exchanged with the peer.
● Recommend: Remote ETS configuration parameters were received from the
peer.
Data Center Bridging (DCB) 383