White Papers

debug dcbx
Enable DCBX debugging.
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail | mgmt |
resource | sem | tlv}
To disable DCBX debugging, use the no debug dcbx command.
Parameters
{all | auto-
detect-timer |
config-exchng |
fail | mgmt |
resource | sem |
tlv}
Enter the type of debugging, where:
● all: enables all DCBX debugging operations.
● auto-detect-timer: enables traces for DCBX auto-detect timers.
● config-exchng: enables traces for DCBX configuration exchanges.
● fail: enables traces for DCBX failures.
● mgmt: enables traces for DCBX management frames.
● resource: enables traces for DCBX system resource frames.
● sem: enables traces for the DCBX state machine.
● tlv: enables traces for DCBX TLVs.
Defaults none
Command Modes EXEC Privilege
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O Aggregator.
description
Enter a text description of the DCB policy (PFC input or ETS output).
Syntax
description text
To remove the text description, use the no description command.
Parameters
text Enter the description of the output policy. The maximum is 32 characters.
Defaults none
Command Modes
● DCB INPUT POLICY
● DCB OUTPUT POLICY
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
368 Data Center Bridging (DCB)