White Papers

match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPF internal
routes only.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of a configured route
map.
Defaults Not configured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
With the Dell Networking OS version 8.3.1.0 and later, you can use the redistribute command to
advertise the IGP cost as the MED on redistributed routes. When you set the route-map with metric-type
internal and apply outbound to an EBGP peer/peer-group, the advertised routes corresponding to those
peer/peer-groups have the IGP cost set as MED.
When you enter the redistribute isis process-id command without any other parameters, the
system redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. RFC does
not support this feature.
router bgp
To configure and enable BGP, enter ROUTER BGP mode.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535 (2 byte), from 1 to 4294967295
(4 byte), or from 0.1 to 65535.65535 (dotted format).
Defaults Not enabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If no
interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
Example
Dell(conf)#router bgp 3
Dell(conf-router_bgp)#
Border Gateway Protocol IPv4 (BGPv4) 301