White Papers

Area Routing for Networks
51 10.10.10.0/00
Routing Protocol is "bgp 1"
Cluster Id is set to 10.10.10.0
Router Id is set to 10.10.10.0
Fast-external-fallover enabled
Regular expression evaluation optimization enabled
Capable of ROUTE_REFRESH
For Address Family IPv4 Unicast
BGP table version is 0, main routing table version 0
Distance: external 20 internal 200 local 200
Dell(conf-router_bgp)#
Related
Commands
show ip protocols — views information on all routing protocols enabled and active.
bgp router-id
Assign a user-given ID to a BGP router.
Syntax
bgp router-id ip-address
To delete a user-assigned IP address, use the no bgp router-id command.
Parameters
ip-address Enter an IP address in dotted decimal format to reset only that BGP neighbor.
Defaults The router ID is the highest IP address of the Loopback interface or, if no Loopback interfaces are
configured, the highest IP address of a physical interface on the router.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Peering sessions are reset when you change the router ID of a BGP router.
bgp soft-reconfig-backup
To avoid the peer from resending messages, use this command only when route-refresh is not negotiated.
Syntax
bgp soft-reconfig-backup
To return to the default setting, use the no bgp soft-reconfig-backup command.
Defaults Off
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Border Gateway Protocol IPv4 (BGPv4) 275