White Papers

2 0000111111000000 1111111111000000 4032 4095 64
3 0001000000000000 1111100000000000 4096 6143 2048
4 0001100000000000 1111110000000000 6144 7167 1024
5 0001110000000000 1111111000000000 7168 7679 512
6 0001111000000000 1111111100000000 7680 7935 256
7 0001111100000000 1111111111000000 7936 7999 64
8 0001111101000000 1111111111111111 8000 8000 1
Total Ports: 4001
Example
An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.
Dell# Data Mask From To #Covered
1 0000000000000000 1111110000000000 0 1023 1024
Total Ports: 1024
Related
Commands
ip access-list extended — creates an extended ACL.
permit — assigns a permit filter for IP packets.
permit udp — assigns a permit filter for UDP packets.
permit icmp
Configure a filter to allow all or specific ICMP messages.
Syntax
permit icmp {source mask | any | host ip-address} {destination mask | any
| host ip-address} [dscp] [message-type] [count [byte]] [order] [fragments]
[threshold-in-msgs [count]]
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● Use the no permit icmp {source mask | any | host ip-address} {destination
mask | any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified
in A.B.C.D format, may be either contiguous or noncontiguous.
any Enter the keyword any to match and drop specific Ethernet traffic on the
interface.
host ip-address Enter the keyword host and then enter the IP address to specify a host IP
address.
destination Enter the IP address of the network or host to which the packets are sent.
dscp Enter the keyword dscp to deny a packet based on the DSCP value. The range is 0
to 63.
message-type (OPTIONAL) Enter an ICMP message type, either with the type (and code, if
necessary) numbers or with the name of the message type. The range is 0 to 255
for ICMP type and 0 to 255 for ICMP code.
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter processes.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL
entry. The range is 0 to 254 (where 0 is the highest priority and 254 is the lowest;
lower-order numbers have a higher priority). If you do not use the keyword order,
the ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
232 Access Control Lists (ACL)