White Papers

vlan vlan-id
Enter the keyword vlan and then enter the VLAN ID to filter traffic associated
with a specific VLAN. The range is 1 to 4094 and 1 to 2094 for ExaScale (you can
use IDs 1 to 4094). To filter all VLAN traffic specify VLAN 1.
source-mac-
address mac-
address-mask
Enter a MAC address and mask in the nn:nn:nn:nn:nn format.
For the MAC address mask, specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows
entries that do not match and a mask of 00:00:00:00:00:00 only allows entries that
match exactly.
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter processes.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL
entry. The range is 0 to 254 (where 0 is the highest priority and 254 is the lowest;
lower-order numbers have a higher priority). If you do not use the keyword order,
the ACLs have the lowest order by default (255).
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes
at which ACL logs must be generated. The interval range is from 1 to 10 minutes.
threshold-in
msgs count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to
indicate the maximum number of ACL logs that can be generated, exceeding
which the generation of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic
that you want to monitor and the ACL in which you are creating the rule is applied
to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring section in
the Port Monitoring chapter of the Dell Networking OS Configuration Guide.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency
at which ACL logs are generated is five minutes. By default, flow-based monitoring is not enabled.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added support for flow-based monitoring on the MXL 10/40GbE Switch IO Module
platform.
9.3(0.0) Added support for logging of ACLs on the MXL 10/40GbE Switch IO Module
platform.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Added the monitor option.
6.5.10 Expanded to include the optional QoS order priority for the ACL entry.
Usage
Information
The monitor option is relevant in the context of flow-based monitoring only. For more information, refer
to Port Monitoring.
The order option is relevant in the context of the Policy QoS feature only. The following applies:
● The seq sequence-number command is applicable only in an ACL group.
Access Control Lists (ACL) 223