White Papers

mask}[ethertype-operator] [count [byte]][log [interval minutes] [threshold-
in-msgs [count]] [monitor]
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● Use the no deny {any | host mac-address | mac-source-address mac-source-
address-mask}{any | host mac-address | mac-destination-address mac-
destination-address-mask}command. command.
Parameters
source Enter the IP address in dotted decimal format of the network from which the
packet was sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or non-contiguous
(discontiguous).
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host and then enter the IP address to specify a host IP address
only.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in
msgs count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to
indicate the maximum number of ACL logs that can be generated, exceeding
which the generation of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes
at which ACL logs must be generated. The time interval range is from 1 to 10
minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic
that you want to monitor and the ACL in which you are creating the rule is applied
to the monitored interface.
Defaults
By default, 10 ACL logs are generated, if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default, flow-based monitoring
is not enabled.
Command Modes CONFIGURATION-IP ACCESS-LIST-STANDARD
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added the support for flow-based monitoring on the MXL 10/40GbE Switch IO
Module.
9.3(0.0) Added the support for logging of ACLs on the MXL 10/40GbE Switch IO Module.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For more information, refer to
the Quality of Service chapter of the Dell Networking OS Configuration Guide.
You can configure either count (packets) or count (bytes). However, for an ACL with multiple rules, you
can configure some ACLs with count (packets) and others as count (bytes) at any given time.
When the configured maximum threshold is exceeded, generation of logs is stopped. When the interval
at which ACL logs are configured to be recorded expires, the subsequent, fresh interval timer is started
Access Control Lists (ACL) 205