White Papers

● range = inclusive range of ports (you must specify two ports for the port
parameter)
port port Enter the application layer port number. Enter two port numbers if you are using
the range logical operand. The range is from 0 to 65535.
The following list includes some common TCP port numbers:
● 23 = Telnet
● 20 and 21 = FTP
● 25 = SMTP
● 169 = SNMP
destination Enter the IP address of the network or host to which the packets are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified
in A.B.C.D format, may be either contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter processes.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL
entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the
lowest; lower-order numbers have a higher priority). If you do not use the keyword
order, the ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in
msgs count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to
indicate the maximum number of ACL logs that can be generated, exceeding
which the generation of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes
at which ACL logs must be generated. The threshold range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic
that you want to monitor and the ACL in which you are creating the rule is applied
to the monitored interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency
at which ACL logs are generated is five minutes. By default, flow-based monitoring is not enabled.
Command Modes CONFIGURATION-IP ACCESS-LIST-EXTENDED
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added support for flow-based monitoring on the MXL 10/40GbE Switch IO Module
platform.
9.3(0.0) Added support for logging of ACLs on the MXL 10/40GbE Switch IO Module
platform.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module platform.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For more information, refer to
the “Quality of Service” chapter of the Dell Networking OS Configuration Guide.
The switch cannot count both packets and bytes, so when you enter the count byte options, only bytes
are incremented.
Most ACL rules require one entry in the CAM. However, rules with TCP and UDP port operators (for
example, gt, lt, or range) may require more than one entry. The range of ports is configured in the CAM
162 Access Control Lists (ACL)