White Papers

fragments Enter the keyword fragments to use ACLs to control packet fragments.
threshold-in-
msgs count
(OPTIONAL) Enter the threshold-in-msgs keyword then a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the
generation of ACL logs are terminated with the seq, permit, or deny commands.
The threshold range is from 1 to 100.
Defaults By default 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency
at which the ACL logs are generated is five minutes.
Command Modes CONFIGURATION-IP ACCESS-LIST-EXTENDED
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.3(0.0) Added the support for logging of ACLs on the MXL 10/40GbE Switch IO Module
platform.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For more information, refer to
the Quality of Service chapter of the Dell Networking OS Configuration Guide.
You can configure either count (packets) or count (bytes). However, for an ACL with multiple rules, you
can configure some ACLs with count (packets) and others as count (bytes) at any given time.
Most ACL rules require one entry in the CAM. However, rules with TCP and UDP port operators (for
example, gt, lt or range) may require more than one entry. The range of ports is configured in the CAM
based on bit mask boundaries; the space required depends on exactly what ports are included in the
range.
When the configured maximum threshold is exceeded, generation of logs is stopped. When the interval
at which ACL logs are configured to be recorded expires, the subsequent, fresh interval timer is started
and the packet count for that new interval commences from zero. If ACL logging was stopped previously
because the configured threshold is exceeded, it is re-enabled for this new interval.
If ACL logging is stopped because the configured threshold is exceeded, it is re-enabled after the logging
interval period elapses. ACL logging is supported for standard and extended IPv4 ACLs, IPv6 ACLs, and
MAC ACLs. You can configure ACL logging only on ACLs that are applied to ingress interfaces; you
cannot enable logging for ACLs that are associated with egress interfaces
Example
An ACL rule with a TCP port range of 4000–8000 uses eight entries in the CAM.
Dell# Data Mask From To #Covered
1 0000111110100000 1111111111100000 4000 4031 32
2 0000111111000000 1111111111000000 4032 4095 64
3 0001000000000000 1111100000000000 4096 6143 2048
4 0001100000000000 1111110000000000 6144 7167 1024
5 0001110000000000 1111111000000000 7168 7679 512
6 0001111000000000 1111111100000000 7680 7935 256
7 0001111100000000 1111111111000000 7936 7999 64
8 0001111101000000 1111111111111111 8000 8000 1
Total Ports: 4001
Example
An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.
Dell# Data Mask From To #Covered
1 0000000000000000 1111110000000000 0 1023 1024
Total Ports: 1024
Access Control Lists (ACL) 157