White Papers

Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module platform.
Usage
Information
You can assign one ACL (standard or extended ACL) to an interface..
NOTE: This command is not supported on the FN IOMSwitch Loopback interfaces.
NOTE: If outbound(egress) IP ACL is applied on switch port, filter will be applied only for routed
traffic egressing out of that port.
Related
Commands
ip access-list standard — configures a standard ACL.
ip access-list extended — configures an extended ACL.
show ip access-lists
Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and the count of matches/
mismatches against each ACL entry displayed.
Syntax
show ip access-lists [access-list-name] [interface interface] [in]
Parameters
access-list-name Enter the name of a configured MAC ACL, up to 140 characters.
interface
interface
Enter the keyword interface then the one of the following keywords and slot/
port or number information:
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
in Identify whether ACL is applied on the ingress or egress side.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show ip access-lists test in
Standard Ingress IP access list test
seq 5 permit 1.1.1.0/24 count (0 packets)
seq 10 deny 2.1.1.0/24 count (0 packets)
show ip accounting access-list
Display the IP access-lists created on the switch and the sequence of filters.
Syntax
show ip accounting {access-list access-list-name | cam_count} interface
interface
Parameters
access-list-name Enter the name of the ACL to be displayed.
146 Access Control Lists (ACL)