White Papers

Parameters
ipv4 | mac Enter the keyword ipv4 or mac to identify the access list type to resequence.
access-list-name Enter the name of a configured IP access list.
StartingSeqNum Enter the starting sequence number to resequence. The range is from 0 to
4294967290.
Step-to-
Increment
Enter the step to increment the sequence number. The range is from 1 to
4294967290.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you have exhausted all the sequence numbers, this feature permits re-assigning a new sequence
number to entries of an existing access-list.
Related
Commands
resequence prefix-list ipv4 — resequences a prefix list.
resequence prefix-list ipv4
Re-assign sequence numbers to entries of an existing prefix list.
Syntax
resequence prefix-list ipv4 {prefix-list-name StartingSeqNum Step-to-
increment}
Parameters
prefix-list-name Enter the name of the configured prefix list, up to 140 characters long.
StartingSeqNum Enter the starting sequence number to resequence. The range is from 0 to 65535.
Step-to-
Increment
Enter the step to increment the sequence number. The range is from 1 to 65535.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you have exhausted all the sequence numbers, this feature permits re-assigning a new sequence
number to entries of an existing prefix list.
Related
Commands
seq — Assigns a sequence number to a deny or permit filter in an IP access list while creating the filter.
Access Control Lists (ACL) 143