White Papers

dot1x supplicant-timeout
Configure the amount of time after which exchanges with the supplicant time-out.
Syntax
dot1x supplicant-timeout seconds
To return to the default, use the no dot1x supplicant-timeout command.
Parameters
seconds Enter a time-out value in seconds. The range is from 1 to 300, where 300 is
implementation dependant. The default is 30.
Defaults 30 seconds
Command Modes INTERFACE
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
dot1x tx-period
Configure the intervals at which EAPOL PDUs the Authenticator PAE transmits.
Syntax
dot1x tx-period seconds
To return to the default, use the no dot1x tx-period command.
Parameters
seconds Enter the interval time, in seconds, that EAPOL PDUs are transmitted. The range is
from 1 to 65535. The default is 30.
Defaults 30 seconds
Command Modes INTERFACE
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
show dot1x cos-mapping interface
Display the CoS priority-mapping table the RADIUS server provides and applies to authenticated supplicants on an 802.1X-
enabled system.
Syntax
show dot1x cos-mapping interface interface [mac-address mac-address]
Parameters
interface Enter one of the following keywords and slot/port or number information:
● For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
mac-address (Optional) MAC address of an 802.1X-authenticated supplicant.
Defaults none
Command Modes
● EXEC
802.1X 135