White Papers

Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP address is configured.
When you delete the virtual address, the VRRP group stops sending VRRP packets.
Related
Command
virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
VRRP for IPv6 Commands
The following commands apply to IPv6.
clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf instance]
Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group. The range is from 1 to 255.
vrf instance (OPTIONAL) Enter the name of a VRF instance (32 characters maximum) to clear
the counters of all IPv6 VRRP groups in the specified VRF.
Defaults Not configured
Command Modes INTERFACE
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: This command also enables you to clear the port configurations corresponding to a range of
ports.
● You can specify multiple ports as slot/port-range. For example, if you want to clear the port
configurations corresponding to all ports between 1 and 4, specify the port range as clear
counters interfacesinterface-type 1/1 - 4.
debug vrrp ipv6
Allows you to enable debugging of VRRP.
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state | timer}
Parameters
interface Enter the following keywords and slot/port or number information:
● For a Port Channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID
range is from 1 to 4094.
vrid (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
1224 Virtual Router Redundancy Protocol (VRRP)