White Papers

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command applies to a single interface. When used with the vrrp delay reload CLI, the later
timer rules the VRRP enabling. For example, if vrrp delay reload is 600 and the vrrp delay
minimum is 300:
● When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces
that are up and configured for VRRP.
● When an interface comes up, whether as part of a system reload or an interface reload, the system
waits 300 seconds (5 minutes) to bring up VRRP on that interface.
Related
Command
vrrp delay reload — sets the delay time for VRRP initialization after a system reboot.
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
Syntax
vrrp delay reload seconds
Parameters
seconds Enter the number of seconds for the delay. The range is from 0 to 900 (0 indicates
no delay).
Defaults 0
Command Modes INTERFACE
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command applies to all the VRRP configured interfaces on a system. When used with the vrrp
delay minimum CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload is
600 and the vrrp delay minimum is 300:
● When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces
that are up and configured for VRRP.
● When an interface comes up, whether as part of a system reload or an interface reload, the system
waits 300 seconds (5 minutes) to bring up VRRP on that interface.
Save the configuration and reload the system for the delay timers to take effect.
Related
Command
vrrp delay minimum — sets the delay time for VRRP initialization after a line card reboot.
vrrp-group
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id Enter a number as the group ID. The range is from 1 to 255.
Defaults Not configured.
Command Modes INTERFACE
Supported Modes Full–Switch
Virtual Router Redundancy Protocol (VRRP) 1223