White Papers

Item Description
● Dn or Up states whether the interface is down or up.
● the interface type slot/port information.
Example
Dell>show vrrp
------------------
TenGigabitEthernet 1/3, VRID: 1, Net: 10.1.1.253
VRF: 0 default
State: Master, Priority: 105, Master: 10.1.1.253 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:01
Virtual IP address:
10.1.1.252
Authentication: (none)
Tracking states for 1 interfaces:
Up TenGigabitEthernet 1/13 priority-cost 10
------------------
TenGigabitEthernet 1/4, VRID: 2, Net: 10.1.2.253
VRF: 0 default
State: Master, Priority: 110, Master: 10.1.2.253 (local)
Hold Down: 10 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:02
Virtual IP address:
10.1.2.252
Authentication: (none)
Tracking states for 2 interfaces:
Up TenGigabitEthernet 2/1 priority-cost 10
Up TenGigabitEthernet 3/8 priority-cost 10
Dell>
track
Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled.
Syntax
track interface [priority-cost cost]
To disable monitoring, use the no track interface command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For Port Channel interface types, enter the keywords port-channel then the
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID
range is from 1 to 4094.
cost (OPTIONAL) Enter a number as the amount to be subtracted from the priority
value. The range is 1 to 254. The default is 10.
Defaults cost = 10
Command Modes VRRP
Supported Modes Full–Switch
Command
History
Version Description
Virtual Router Redundancy Protocol (VRRP) 1221