White Papers

Defaults Not enabled.
Command Modes VRRP
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
disable
Disable a VRRP group.
Syntax
disable
To re-enable a disabled VRRP group, use the no disable command.
Defaults Enabled.
Command Modes VRRP
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To enable VRRP traffic, assign an IP address to the VRRP group using the virtual-address command
and enter no disable.
Related
Commands
virtual-address — specifies the IP address of the virtual router.
hold-time
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the initialization of the VRRP
MASTER, the new switch can stabilize its routing tables.
Syntax
hold-time {seconds | centisecs centisecs}
To return to the default value, use the no hold-time command.
Parameters
seconds Enter a number of seconds. The range is from 0 to 65535. The default is zero (0)
seconds.
centisecs
centisecs
Enter the keyword centisecs then the number of centisecs in units of 25
centisecs. The range is from 0 to 65525 in units of 25 centisecs.
Defaults zero (0) seconds
Command Modes VRRP
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.5(0.0) Introduced the support for centisecs on the MXL 10/40GbE Switch.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Virtual Router Redundancy Protocol (VRRP) 1217