White Papers

Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: This command also enables you to clear the port configurations corresponding to a range of
ports.
● You can specify multiple ports as slot/port-range. For example, if you want to clear the port
configurations corresponding to all ports between 1 and 4, specify the port range as clear
counters interfaces interface-type 1/1 - 4.
debug vrrp
Allows you to enable debugging of VRRP.
Syntax
debug vrrp interface [vrrp-id] {all | packets | state | timer}
To disable debugging, use the no debug vrrp interface [vrrp-id] {all | packets |
state | timer} command.
Parameters
interface Enter the following keywords and slot/port or number information
● For Port Channel interface types, enter the keywords port-channel then the
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID
range is from 1 to 4094.
vrrp-id (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all Enter the keyword all to enable debugging of all VRRP groups.
packets Enter the keyword packets to enable debugging of VRRP control packets.
state Enter the keyword state to enable debugging of VRRP state changes.
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you do not specify options, debug is active on all interfaces and all VRRP groups.
description
Configure a short text string describing the VRRP group.
Syntax
description text
To delete a VRRP group description, use the no description command.
Parameters
text Enter a text string up to 80 characters long.
1216 Virtual Router Redundancy Protocol (VRRP)