White Papers

Ndp Reg Request rcvd:1
VLT multicast not enabled
stack-unit iom-mode
Set the switch operating mode to VLT mode.
Syntax
stack-unit <unit-number> iom-mode vlt
Parameters
unit number
<0-5>
Enter the number of the member stack unit. The range is from 0 to 5. The default
is 0.
vlt Enable virtual link trunking mode.
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Usage
Information
This command resets the operating mode to VLT. You must reboot the switch after using this command.
system-mac
Reconfigure the default MAC address for the domain.
Syntax
system-mac mac-address
Parameters
mac-address Enter the system MAC address for the VLT domain.
Defaults Not configured.
Command Modes VLT DOMAIN
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Usage
Information
When you create a VLT domain on a switch, Dell Networking OS automatically creates a VLT-system
MAC address used for internal system operations.
To reconfigure the default MAC address for the domain by entering a new MAC address in the format
nn:nn:nn:nn:nn:nn, use the system-mac command.
You must also reconfigure the same MAC address on the VLT peer switch.
Virtual Link Trunking (VLT) 1211