White Papers

back-up destination
Configure the IPv4 or IPv6 address of the management interface on the remote VLT peer to be used as the endpoint of the VLT
backup link for sending out-of-band hello messages.
Syntax
back-up destination {[ipv4–address] | [ipv6 ipv6–address] [interval
seconds]}
Parameters
ipv4–address Enter the IPv4 address of the backup destination.
ipv6 Enter the keyword ipv6 then an IPv6 address in the X:X:X:X::X format.
interval seconds Enter the keyword interval to specify the time interval to send hello messages.
The range is from 1 to 5 seconds. The default is 1 second.
Defaults 1 second
Command Modes VLT DOMAIN
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree
information base, use the clear ip pim tib command.
Syntax
clear ip mroute {group-address [source-address] | * | snooping}
Parameters
group-address
[ source-address ]
Enter the multicast group address and source address (if desired), in dotted
decimal format, to clear information on a specific group.
* Enter * to clear all multicast routes.
snooping Enter the keyword snooping to delete multicast snooping route table entries.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
clear ip pim tib
Clear PIM tree information from the PIM database.
Syntax
clear ip pim tib [group]
Parameters
group (OPTIONAL) Enter the multicast group address in dotted decimal format (A.B.C.D).
1200 Virtual Link Trunking (VLT)