White Papers

member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible command in
its configuration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults Not configured.
Command Modes conf-if-vl-<vlan-id>-stack
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You must enable the stackable VLAN (using the vlan-stack compatible command) on the VLAN
prior to adding a member to the VLAN.
Related
Commands
vlan-stack compatible — enables stackable VLAN on a VLAN.
show interface dei-honor
Display the dei honor configuration.
Syntax
show interface dei-honor [interface slot/port]
Parameters
interface slot/
port
Enter the interface type then the line card slot and port number.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show interface dei-honor
Default Drop precedence: Green
Interface CFI/DEI Drop precedence
---------------------------------------------
Te 0/1 0 Green
Te 0/1 1 Yellow
Te 1/9 1 Red
Te 1/12 0 Yellow
Dell#show interface dei-honor
VLAN Stacking 1193